我家的吸塵機_600字

Power switch　

　　The power switch is located on the end of the curved handle.　

　　To turn hand vacuum ON ( I ), press up.　

　　To turn hand vacuum OFF ( 0 ), press down　

　　Cleaning with flexible rubber contour nozzle　

　　1. Turn hand vacuum OFF.　

　　2. Remove hard nozzle by pressing down on　

　　round nozzle release button.　

　　3. Replace with flexible rubber contour nozzle by lining　

　　up the bottom of nozzle to the bottom of the dirt　

　　container. Pivot upwards until it snaps into place.　

　　4. Make sure the nozzle has snapped securely　

　　into place before using　

　　Emptying the dirt container　

　　Empty the dirt container after each use. A　

　　full dirt container may reduce suction or　

　　performance of vacuum.　

　　1. Turn hand vacuum OFF.　

　　2. Unplug hand vacuum from electrical outlet.　

　　3. Press dirt container release latch down to　

　　disconnect dirt container and filter assembly　

　　from the unit.　

　　4. Remove filter by grasping tabs on both sides　

　　of filter frame and pulling away from the dirt　

　　container. For best results, periodically tap　

　　filter assembly against trash can to remove　

　　dirt that has collected on the screen and　

　　filter.　

　　5. Empty dirt into trash can.　

　　6. Replace filter assembly by aligning side　

　　labeled “TOP” into top of dirt container.　

　　Grasp filter tabs and press firmly to ensure　

　　filter assembly is secure in dirt container.　

　　NOT E: Make sure side of filter assembly　

　　labeled "TO P" faces outward when inserting　

　　filter assembly into dirt container.　

　　7. Reattach dirt container to unit by aligning　

　　bottom of dirt container to bottom of unit.　

　　Pivot upwards and snap into place. Use one　

　　hand to hold the unit and use the other hand　

　　to clip the dirt container securely in place